Yokogawa YFGW510 - Manual (Page 38)

<C5. Wiring>
C5-6
IM 01W02E01-01EN
l Optical network cable connection procedure
Connect the optical network cable in the following procedure.
1. Insert the optical network cable through the YFGW510 network cable gland.
2. Insert the connector through the YFGW510 connection and screw in the cable gland.
3. Connect the optical network cable to the SC connector of the device. Do not bend the opti-
cal network cable at a sharp angle.
4. The optical network cable consists of a pair of wires. One wire is used for sending signals
and the other for receiving signals (TX/RX). The polarity of the YFGW510 SC connector is
indicated on the connector label. If polarity is indicated on the optical network cable, follow
the indication. If not, the wires can be connected to either port. The polarity can be easily
changed on YFGW610.
FC0504.ai
SC connector
label for connection
Optical network cable
Cable gland for
Network Cable
Figure C5-4 Connecting optical network cable