Yokogawa YFGW510 - Manual (Page 46)

<C5. Wiring>
C5-14
IM 01W02E01-01EN
n Wiring of wireless LAN antenna and improvement of environmental
resistance
l Specification of extension cable for wireless LAN antenna
(Use only the cables included as option.)
• Specification: 8D-SFA(PE)
• Outside Diameter: 11.1 mm
• Minimum Bend Radius: 67 mm (when fixing)
167 mm (when wiring)
• Cable End Treatment: N type connector, one end is male and the other is female.
* “When fixing” shows the bending radius for fixing (the state is maintained for a long time).
“When wiring” shows the bending radius while checking the wiring position. This bending
radius is set larger than that for fixing in order to prevent damage to the cable because the
cable is likely to be repeatedly bent when checking the final wiring position.
l Wiring procedure of wireless LAN antenna
1. Use the provided antenna extension cable to connect the antenna connector with the re-
mote antenna. Tighten the connector of the antenna extension cable with a torque of 2 to 3
N∙m. Refer to the specification about the limitation of bend radius when fixing or wiring.
2. When using two antenna extension cables, the provided arrestor should be inserted be-
tween these cables.
3. Before the wiring work, confirm the polarities (male/female) of the connectors of antenna,
antenna extension cable, and arrestor.
Tighten the connector of the antenna extension cable with a torque of 2 to 3 N∙m.
FC0512.ai
Wireless LAN antenna
Wireless LAN antenna
Antenna Extension Cable
Antenna Extension Cable
Bracket
Bracket
Mounting YFGW510 to the vertical piping Mounting YFGW510 to the horizontal piping
2-inch pipe
2-inch pipe
Figure C5-12 Wiring of wireless LAN antenna (wireless LAN single model)