Yokogawa µR10000 - Manual (Page 21)

21
IM 04P01B01-02E
Common Operations and Menu Structure
Execution Modes
The recorder has three execution modes.
Operation Mode
This mode is used for normal recording operation. The recorder enters this mode when
the power is turned ON.
Setting Mode
This mode is used to set the input range, alarms, chart speed, and other parameters.
These settings can be changed while recording is in progress. However, the input
range of measurement channels and the computing equation, unit, constant, and TLOG
setting of computation channels cannot be changed while computation (/M1 option) is in
progress.
Basic Setting mode
This mode is used to set the basic specifications of the recorder such as the
thermocouple burnout detection function and the alarm output relay operation. This mode
cannot be entered while the recorder is recording or while computation is in progress
on the computation function (/M1 option). Measurement, recording, and alarm detection
cannot be carried out in this mode.
Operation mode
Power ON
Setting mode
Data display setup screen
Basic Setting mode
MENU 1
Display “End=Store” and press
MENU
Hold down
for 3 s
Hold down
Hold down
+ for 3 s
for 3 s
Data display screen
Operation Sequence
This section explains the operations that need to be carried out when using the recorder
for the first time.
• Preparing to Record
Load the chart paper and pens (pen model) or ribbon cassette (dot model). Change
the date/time if necessary.
For the operating procedure, see page 27.
• Setting the Channel Input Range and Other Parameters
Set the measurement conditions suitable for the object being measured.
This manual explains the following operations.
• Setting the input range and alarm (see page 33 for the procedure)
• Changing the chart speed (see page 42 for the procedure)
• Recording/Displaying Data
Start/Stop the recording operation and carry out various types of printouts. Also,
switch the display screen and change the displayed contents.
For the operating procedure, see page 41.