Nematron Pointe Controller - Manual (Page 287)

Pointe Controller User Guide Appendix A: OptiLogic Technical Specifications
285
This tab configures the six white indicator bars on the OL3406 panel.
Indicator n – Bit that turns the indicator on/off. When the bit becomes
ON, the indicator is turned on. When the bit becomes OFF, the indicator is
turned OFF. Mapped to an Output Bit tag (%QX).
To configure an Indicator, click the to the right and select a tag from
the pop-up menu. Each tag can be used only once.
Indicator n Flash – Bit that quickly flashes the indicator. (The indicator
itself must already be on.) When the bit becomes ON, the indicator starts
flashing. When the bit becomes OFF, the indicator stops flashing. Mapped
to an Output Bit (%QX).
To configure an Indicator Flash, click the to the right and select a tag
from the pop-up menu. Each tag can be used only once.
NOTE: You can leave any or all Indicators unconfigured, but if you do, those I/O
points will not be available to your project.
Buttons tab
This tab controls the four white pushbuttons on the OL3406 panel.
LED Separation – Option to control the red LEDs embedded in the
pushbuttons, separate from the actual ON/OFF states of the buttons. (The
setting applies to all four buttons.)
o If Disabled (default), then each button’s LED directly reflects the
current ON/OFF state of the button.