Mammoth V-Cube - Manual (Page 41)

a frame bank of multiple frames, install the lower filters
first so that the upper filters can rest on the lower filters.
Step 3
Place a latch so that it overlaps the leg extension, as
shown below in Figure D6. Align the latch’s cap screw
with the threaded coupling on the end of the leg exten-
sion and tighten using the hexkey. Tighten the cap screw
until there is an approximately ¼” gap between the latch
and the leg extension coupling as shown below in Figure
D7. Repeat this step with all four corners.
Step 4
Once all four corner latches have been tightened within
¼” of the leg extension coupling, complete the installation
by tightening each corner until the latch and leg extension
coupling meet, as illustrated in Figure D8.
Once all four corners have been tightened, the filter
should now be properly seated and sealed.
Repeat the process with all remaining filters working from
the bottom to the top.
Figure D5: Filter placed inside of frame
Figure D6: Latch overlapping leg extension
Figure D7: Tighten cap screw to ¼” of the coupling
Figure D8: Tighten until latch and coupling meet
Figure D9: Properly installed filter
VCES-V-CUBE-IOM-1A 41