Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 196)

FIGURE 27 LSAN zones example
The following example steps create this set of LSAN zones.
1. Obtain the host WWN in fabric_01:
a) Log in to any switch in fabric_01.
b) On the fabric_01 switch, enter the show name-server detail command to list the WWN of
the host (10:00:00:00:c9:2b:c9:0c).
NOTE
The show name-server detail output displays both the port WWN and node WWN; the
port WWN must be used for LSANs.
switch# show name-server detail
PID: 012100
Port Name: 10:00:00:00:c9:2b:c9:0c
Node Name: 20:00:00:00:c9:2b:c9:0c
SCR: 3
FC4s: FCP
PortSymb: [27] "Brocade-1020|2.3.0.0|localhost.localdomain|Red Hat
Enterprise Linux Server release 5.5"
NodeSymb: NULL
Fabric Port Name: 20:21:00:05:1E:CD:79:7A
Permanent Port Name: 10:00:00:00:c9:2b:c9:0c
Device type: Physical Initiator
Interface: Fcoe 1/1/9
Physical Interface: Te 1/0/9
Share Area: No
Redirect: No
2. Obtain the target WWNS in fabric_02:
a) Log in as admin on switch2 in fabric_02.
b) On fabric_02, enter the nsShow command to list Target A (50:05:07:61:00:5b:62:ed) and
Target B (50:05:07:61:00:49:20:b4).
switch:admin> nsshow
{
Type Pid COS PortName NodeName TTL(sec)
NL 0508e8; 3; 50:05:07:61:00:5b:62:ed; 50:05:07:61:00:1b:62:ed; na
FC4s: FCP [IBM DNEF-309170 F90F]
Administering Zones
196 Network OS Administrator’s Guide
53-1003225-04