Brocade Network OS Administrator’s Guide v4.1.1 User Manual
Page 582
Advertising
j)
Enable PIM Sparse for this interface.
switch (config-ve-10)# ip pim-sparse
k)
Exit Ve configuration mode.
switch (config-ve-10)# end
l)
Repeat the configuration steps for each of the other VLANs shown in the example figure
for a deployment using a single VCS in
NOTE
For more information about PIM, refer to the Network OS Command Reference. Global
PIM CLIs are found in RBridge ID configuration mode, whereas the interface-level PIM
CLIs are found under their respective interface subconfiguration modes.
Configuring PIM
582
Network OS Administrator’s Guide
53-1003225-04
Advertising