Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 518)

-----------
nas server-ip 10.1.1.1/32 vrf default-vrf
matches 0 packets 0 bytes
switch# show nas statistics server-ip 10.1.1.0/24 vrf brad
nas server-ip 10.1.1.0/24 vrf brad
matches 2000000 packets 40000000 bytes
Clearing NAS server statistics
You can use this command to clear the statistics for a single IPv4 address (10.192.100.100/32), or an
entire sub-net (10.192.100.0/24 vlan 100). When a subnet is specified, the NAS statistics for all the
servers in the sub-net will be cleared. Subnet masks are not supported (for example: 10.192.100.0
255.255.255.0 is not a supported address).
1. To clear NAS server statistics for a single server, enter: show nas statistics server-ip followed by
the IPv4 address and the appropriate VLAN or VRF mask and RBridge ID.
The following example shows clearing the NAS statistics for “10.1.1.0/24 vrf brad” and then the
effect of this clearing.
switch# clear nas statistics server-ip 10.1.1.0/24 vrf brad
switch# show nas statistics server-ip 10.1.1.0/24 vrf brad
nas server-ip 10.1.1.0/24 vrf brad
matches 0000000 packets 00000000 bytes
2. To clear all NAS server statistics, enter clear nas statistics all.
Clearing NAS server statistics
518 Network OS Administrator’s Guide
53-1003225-04