Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 283)

FIGURE 35 Windows server VSA configuration
Configuring client side RADIUS support
Each Brocade switch client must be individually configured to use RADIUS servers. You use the
radius-server command to specify the server IP address, authentication protocols, and other
parameters. You can configure a maximum of 5 RADIUS servers on a Brocade switch for AAA service.
NOTE
RADIUS requires that you configure both the client and the server.
The following table describes the parameters associated with a RADIUS server that is configured on the
switch.
RADIUS server parameters TABLE 49
Parameter Description
host IP address (IPv4 or IPv6) or host name of the RADIUS server. Host name requires
prior DNS configuration. The maximum supported length for the host name is 40
characters.
auth-port The user datagram protocol (UDP) port used to connect the RADIUS server for
authentication. The port range is 0 through 65535; the default port is 1812.
Configuring client side RADIUS support
Network OS Administrator’s Guide 283
53-1003225-04