Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 413)

The following table lists those switch defaults which apply only to MSTP configurations.
Default MSTP configuration TABLE 68
Parameter Default setting
Cisco interoperability Disabled
Switch priority (when mapping a VLAN to an
MSTP instance) 32768
Maximum hops 20 hops
Revision number 0
The following table lists the switch defaults for the 10-gigabit Ethernet DCB interface-specific
configuration.
Default 10-gigabit Ethernet DCB interface-specific configuration TABLE 69
Parameter Default setting
Spanning tree Disabled on the interface
Automatic edge detection Disabled
Path cost 2000
Edge port Disabled
Guard root Disabled
Hello time 2 seconds
Link type Point-to-point
Port fast Disabled
Port priority 128
DCB interface root port Allow the DCB interface to become a root port.
DCB interface BPDU restriction Restriction is disabled.
Saving configuration changes
Enter the copy running-config startup-config command to save your configuration changes.
Saving configuration changes
Network OS Administrator’s Guide 413
53-1003225-04