Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 92)

Using hardware profile show commands
You can view route table and TCAM profiles in the running configuration, and also see the current
active profile information and subtype details for each profile type and RBridge ID, as in the following
examples. Refer also to the show hardware-profile command in the Network OS Command
Reference.
Displaying hardware profile configuration on the local switch
The following shows the use of the show running-config rbridge-id
hardware-profile command, without the specification of an RBridge ID, to
display the results of the configuration on the local switch.
switch# show running-config rbridge-id hardware-profile
rbridge-id 11
hardware-profile tcam ipv4-v6-mcast
hardware-profile route-table ipv6-max-nd
!
rbridge-id 12
hardware-profile tcam l2-ipv4-acl
hardware-profile route-table ipv4-max-arp
Using hardware profile show commands
92 Network OS Administrator’s Guide
53-1003225-04