Brocade Network OS Administrator’s Guide v4.1.1 - Manual (Page 81)

Examples of global and local configurations
The table below provides examples of global and local configuration commands that are available under
the respective configuration modes. These settings can be viewed respectively by means of the show
global-running-config command and the show local-running-config command.
Global and local configuration commands TABLE 6
Global Local
Interface vlan switch-attributes
interface port-channel interface management
port-profile interface ve
mac access-list diag post
ip access-list dpod
sflow switch-attributes
snmp-server fabric route mcast
protocol lldp rbridge-id
zoning ip route
cee-map linecard
username router ospf
router bgp
protocol vrrp
vrrp-group
interface management
interface gigabitethernet
interface tengigabitethernet
interface fortygigabitethernet
interface fcoe
Use the copy snapshot commands if you need to upload or download configuration snapshot files to
and from an ftp or scp server. You may need to use these commands if you took a snapshot of a
configuration on a node that was disconnected from the cluster.
Refer to the Network OS Command Reference for detailed information about these and other logical
chassis server commands.
Examples of global and local configurations
Network OS Administrator’s Guide 81
53-1003225-04