Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 20)

Port status LEDs (Continued) TABLE 3
LED Condition Status
On/Flashing Yellow The SFP port is operating at 1 Gbps. Flashing
indicates the port is transmitting and receiving user
packets.
Off A link is not established with a remote port.
Out of band management port (2
LEDs) Off (both LEDs) Offline
On/Flashing (right side) Link-up. Flashing indicates the port is transmitting
and receiving user packets.
Green (left side) 1000Mbps Link-up
Left LED off, right LED
on or flashing 10/100Mbps Link-up. Flashing indicates the port is
transmitting and receiving user packets.
1 System status LEDs
FIGURE 13 System status LEDs
System status LEDs TABLE 4
LED Condition Status
PS1
PS2
(Power Supply Status)
Green Power supply is operating normally.
Yellow Power supply fault.
Off Power off or failure.
Diag
(Diagnostic)
Flashing Green System self-diagnostic test in progress.
Green System self-diagnostic test successfully completed.
Yellow System self-diagnostic test has detected a fault. (Blower,
thermal or any interface fault.)
MS
(Stacking configuration)
Green The device is the Active controller. Flashing indicates the
system is initializing.
Yellow Indicates the device is the Standby controller. Flashing indicates
the system is in Master arbitration/selection state.
ICX 6610 Overview
18 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02