Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 31)

2-Post rack mount installation
NOTE
Use the following procedure when installing the Brocade ICX 6610 device in a 2-post rack. For 4-post
racks, follow the procedures in the section
4-Post rack mount installation on page 33.
Remove the rack mount kit from the shipping carton. The kit contains the following:
• Two L-shaped mounting brackets.
• Sixteen 8-32 x 3/8 in., panhead Phillips screws with patchlocks.
• Four 10-32 x 5/8 in., panhead Phillips screws (torque to 25 in-lb, 29 cm-kg)
• Eight 32-10 retainer nuts (for square-hole rack rails)
• Eight 32-10 retainer nuts (for round-hole rack rails)
1 Bracket, front right
2 Bracket, front left
3 Screw, 8-32 x 3/8 in., panhead Phillips
4 Screw, 10-32 x 5/8 in., panhead Phillips
5 Retainer nut, 10-32, (for square-hole
rack rails)
6 Retainer nut, 10-32, (for round-hole
rack rails)
FIGURE 19 2-post rack mount kit for Brocade ICX 6610
2-Post rack mount installation
Brocade ICX 6610 Stackable Switch Hardware Installation Guide 29
53-1003082-02