Brocade ICX 6610 Stackable Switch Hardware Installation Guide User Manual
Page 36
‐
Eight 32-10 retainer nuts (for square-hole rack rails).
‐
Eight 32-10 retainer nuts (for round-hole rack rails)
1
Bracket, front right
2
Bracket, front left
3
Bracket extensions up to 34 in.
4
Bracket extensions, up to 27 in.
5
Screw, 8-32 x 3/8 in., panhead Phillips
6
Screw, 10-32 x 5/8 in., panhead Phillips
7
Retainer nut, 10-32, (for square-hole
rack rails)
8
Retainer nut, 10-32, (for round-hole
rack rails)
FIGURE 24 4-post rail kit
Use the steps below to mount devices in a 4-post rack.
CAUTION
Do not use the hardware supplied in a 2-post rack mounting kit to mount a Brocade ICX 6610
device in a 4-post rack. Mounting the device in a 4-post rack requires additional hardware to
prevent drooping from possible flexing and distortion of the 4-post rack when a device is not
properly installed.
1.
Attach the mounting brackets to the sides of the device, using the 8-32 x 3/8 in. screws.
Installing the ICX 6610 Switch
34
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02