Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 54)

NOTE
You need to run a terminal emulation program on the PC.
2. Launch the terminal emulation program and set the following session parameters:
• ‐ Baud: 9600 bps
‐ Data bits: 8
‐ Parity: None
‐ Stop bits: 1
‐ Flow control: None
The console serial communication port serves as a connection point for management by a PC or
SNMP workstation.
Powering on the system
Complete the physical installation before you power on the system.
1.
NOTE
The socket should be installed near the equipment and should be easily accessible.
Remove the power cable from the shipping container.
2. Attach the power cable to the power connector.
3. Insert the power cable plug into a 100V-240VAC outlet if your unit uses AC power or a 40-70VDC
outlet if your unit uses DC power.
NOTE
To turn the system off, simply unplug the power cable or cables.
Power supplies for the Brocade ICX 6610
Each ICX 6610 ships by default with one alternating current (AC) power supply. A second power
supply can be added. The ICX 6610 can also be ordered with direct current (DC) power supplies.
CAUTION
When running two power supplies, they must be of the same type: either two alternating
current (AC) power supplies or two direct current (DC) power supplies. AC and DC units cannot
be mixed in a device.
If power supplies are inadvertently mismatched, the device will continuously reboot when powered on.
If a second power supply is installed and does not match the primary power supply, it will not be
operational.
Powering on the system
52 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02