Brocade ICX 6610 Stackable Switch Hardware Installation Guide User Manual
Page 45
Ports used to connect ICX 6610 devices to ICX 6450 devices
There are eight SFP+ ports in slot 3 on the front panel of an ICX 6610 device that are used to connect
ICX 6610 devices to ICX 6450 devices in a mixed stack.
NOTE
Without a license at bootup, the SFP+ ports come up in 10 Gbps port speed in an error-disabled state.
To enable the SFP+ ports to 10 Gbps port speed, you must purchase the ICX6610-10G-LIC-POD
license for each ICX 6610 SFP+ port that connects to an ICX 6450 device.
Maximum number of ports you can use on an ICX 6610 device to connect to ICX 6450 devices
Any one ICX 6610 device supports a maximum of:
•
Two trunk connections to ICX 6450 peripheral devices (four ports total).
•
Two single (untrunked) port connections to ICX 6450 peripheral devices.
FIGURE 33 SFP+ ports on the front panel of the 24-port model of an ICX 6610 device
1
Slot 3: 10 Gbps SFP+ ports 1-8
2
Slot 1: 10/100/1000 Mbps ports
FIGURE 34 SFP+ ports on the front panel of the 48-port model of an ICX 6610 device
1
Slot 3: 10 Gbps SFP+ ports 1-8
2
Slot 1: 10/100/1000 Mbps ports
Ports used to connect ICX 6610 devices to ICX 6450 devices
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
43
53-1003082-02