Installing a transceiver – Brocade ICX 6610 Stackable Switch Hardware Installation Guide User Manual
Page 72
Advertising
Supported SFP transceivers (Continued)
TABLE 13
Optic
Distance
1000Base-CWDM
80km
1000Base-BXU
10km
1000Base-BXD
10km
100Base-FX
2km
100Base-FX-IR
15km
100Base-FX-LR
40km
10GSFPP-SR
300m
10GSFPP-LR
10km
Installing a transceiver
You can install a new transceiver in an SFP or SFP+ slot while the device is powered on and running.
While installing a transceiver, wear an ESD wrist strap with a plug for connection to a metal surface.
NOTE
For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.
CAUTION
All fiber optic interfaces use Class 1 lasers.
Use the following steps to install a transceiver:
Installing a transceiver
70
Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02
Advertising