Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 57)

Installing a DC power supply
NOTE
You need a #2 Phillips screwdriver and a flat-head screwdriver for installation.
Use the following steps to install a DC power supply in the switch.
CAUTION
Ensure that the power type of the power supplies match. Both power supplies must be either AC
or DC. AC and DC units cannot be mixed in a device.
FIGURE 43 DC power supply unit
Installing a DC power supply
Brocade ICX 6610 Stackable Switch Hardware Installation Guide 55
53-1003082-02