Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 165)

Brocade Mobility RFS7000-GR Controller System Reference Guide 151
53-1001944-01
Viewing associated MU details
4
1. Select Network > Mobile Units from the main menu tree.
2. Click the Status tab.
The Status screen displays the following read-only device information for MUs interoperating
within the switch managed network.
Station Index Displays a numerical device recognition identifier for a specific MU.
MAC Address Each MU has a unique Media Access Control (MAC) address through which it is
identified. This address is burned into the ROM of the MU.
MAC Name Displays the MAC name associated with each MU's MAC Address. The MAC Name
is a user created name used to identify individual mobile unit MAC Addresses with
a user friendly name.
IP Address Displays the unique IP address for the MU. Use this address as necessary
throughout the applet for filtering and device intrusion recognition and approval.
Ready Displays whether the MU is ready for switch interoperation. Values are Yes and No.
Session Timeout Displays the session timeout values for each of the listed MUs.
Power Save Displays the current (read-only) Power-Save-Poll (PSP) state of the MU. The Power
Save field has two potential settings. PSP indicates the MU is operating in Power
Save Protocol mode. In PSP, the MU runs enough power to check for beacons and
is otherwise inactive. CAM indicates the MU is continuously aware of all radio
traffic. CAM is recommended for MUs frequently transmitting with the switch’s
Access Ports for periods of two hours or greater.
WLAN Displays the name of the WLAN the MU’s associated AP is connect to.
VLAN Displays the specific VLAN the target MU is mapped to.
Tunnel Displays the tunnel the target MU is mapped to.