Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 303)

Brocade Mobility RFS7000-GR Controller System Reference Guide 289
53-1001944-01
Configuring self healing
5
1. Select Services > Self Healing from the main menu tree.
The Self Healing page launches with the Configuration tab displayed.
2. Select the Enable Neighbor Recovery checkbox.
Enabling Neighbor Recovery is required to conduct manual neighbor detection.
3. Refer to the Interference Avoidance field to define the following settings:
4. Click the Apply button to save the changes made within this screen. Clicking Apply overwrites
the previous configuration.
5. Click the Revert button to disregard any changes made within this screen and revert back to
the last saved configuration.
Configuring self healing neighbor details
The Neighbor Details page displays all the radios configured on the switch and their neighbor
designations.
To configure self-healing on the switch:
Enable Interference
Avoidance When enabled, the switch is capable of switching channels on an Access Port
(Automatic Channel Selection) if interference is observed on the current operating
channel.
Average Retries Displays the average number of retries for a MU to communicate with a neighbor
radio. Define a retry value between 0.0 and 15.0 retry attempts. Average Retries is
a threshold value, when exceeded ACS is initiated.
Hold Time Set the interval (in seconds) that disables interference avoidance after detection.
The hold time prevents the radio from re-running ACS continuously.