Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 57)

Brocade Mobility RFS7000-GR Controller System Reference Guide 43
53-1001944-01
Viewing the switch interface
3
1. Refer to the Alarms field for details of all the unacknowledged alarms generated during the
past 48 hours. The alarms are classified as:
• Critical — Denoted by a red indicator. These alarms warrant immediate attention.
• Major — Denoted by a yellow indicator. These alarms warrant attention.
• Others — Denoted by a blue indicator.
The alarms field also displays details (in a tabular format) of the 5 most recent
unacknowledged critical/major alarms raised during the past 48 hours. The table displays the
following details:
2. Refer to the Ports field for link, speed and duplex status of each physical port on the switch’s
front panel. It displays the following details in a tabular format:
3. The Environment section displays the CPU temperature . It displays the valid threshold range
set by the user.
4. The CPU/Memory section displays the free memory available with the RAM.
5. The File Systems section displays the free file system available for:
• flash
• nvram
Management IP
Displays the management IP address of the switch.
Access Ports
Displays the total number of Access Ports adopted by the switch.
Mobile Units Displays the total number of MUs associated with the switch.
Up Time Displays the actual switch uptime. The Up Time is the current operational time of
the device defined within the System Name field. Uptime is the cumulative time
since the switch was last rebooted or lost power.
Severity Displays the severity of the alarm. It can be either Critical or Major.
Last Occurrence Displays the time when the alarm was reported.
Message Displays the message associated with the alarm.
# Occurrences Displays the number of times during the past 48 hours such an alarm was
generated.
Name Displays the name of the port (ge1, ge2, ge3, ge4 and me1).
Status Displays the status of the port, either— Up or Down
Speed Displays the speed at which the port transmits or receives data.
Duplex Displays the status of the port, either— Full Duplex or Unknown.