Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 316)

302 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Locationing
5
5. Click the Apply button to save the MU Locate Interval value.
6. Click the Revert button to cancel any changes made within MU Locate Interval value and revert
back to the last saved configuration.
NOTE
AP coordinates can only be configured in the Command Line Interface. For more information on
configuring AP coordinates please consult the Brocade Mobility RFS7000-GR Controller CLI
Reference Guide.
7. The MU MAC table allows you to manually add or remove MAC Addresses which can be located
by the SOLE engine. This supports a maximum of 512 MUs. This table is disabled when the
Locate All MUs checkbox is selected.
a. To add MUs to the MU MAC table click the Add button to open a dialogue box allowing you
to add a MAC Address to the MU MAC table allowing it to be located by the switch's SOLE
engine.
b. To remove a MAC Address from the MU MAC table select a MAC Address from the table
and click the Delete button to remove that MU. This table is disabled when the Locate All
MUs checkbox is selected.
Once SOLE has been enabled MUs found by the locationing engine will be displayed in the Located
MUs table at the bottom of the page. For each located MU the following information is displayed:
NOTE
Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Brocade Mobility RFS7000-GR Controller CLI Reference Guide.
MAC Lists the MAC Addresses of all MUs which have been located by the switch.
Location:
X Coordinate Displays the value of the X Coordinate for each located MU. The X coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Location:
Y Coordinate Displays the value of the Y Coordinate for each located MU. The Y coordinate is
relative to the origin point of 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each MU that its location was computed by the switch.
Zone Lists the last known zone for each located MU. Zone configuration can be defined
using the CLI interface only. When no zones are configured, the switch defaults the
entire site to Zone 0.