Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 194)

182 Brocade Mobility 7131N-FGR Product Reference Guide
53-1001947-01
Configuring VPN tunnels
6
1. Ensure the WAN ports are connected via the internet
2. Select Network Configuration -> WAN -> VPN from the Brocade Mobility 7131N-FGR Access
Point menu tree.
3. Enter any tunnel name (tunnel names do not need to match).
4. Enter the WAN port IP address of AP #1 in the Local WAN IP field
5. Enter the LAN IP subnet and mask of AP #2 in the Remote Subnet and Remote Subnet Mask
fields,
6. Enter the WAN port IP address of AP #2 in the Remote Gateway field
7. Click Add to add the tunnel to the list.
8. Select the Auto (IKE) Key Exchange button.
9. Select Auto Key Settings.
10. Select ESP with Authentication and AES 128-bit. Click OK.
11. Select the IKE Settings button.
12. Select Pre Shared Key (PSK).
13. Enter the Passphrase.
Passphrases must match on both VPN devices.
14. Select AES 128-bit.
15. Select Group 2.
16. Click OK.
This will take you back to the main VPN configuration screen.
17. Click Apply to save the updates
18. Select Network Configuration -> WAN -> VPN -> VPN Status from the Brocade Mobility
7131N-FGR Access Point menu tree. Check the VPN status on the access point.