Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 325)

Brocade Mobility 7131N-FGR Product Reference Guide 313
53-1001947-01
Network commands
8
BR7131N>admin(network.wireless.wlan)> create
Defines the parameters of a new WLAN.
Syntax
Example
admin(network.wireless.wlan.create)>show wlan
create
show wlan <number> Displays newly created WLAN and policy number.
set ess <essid> Defines the ESSID for a target WLAN.
wlan-name <name> Determines the name of this particlular WLAN
(1-32).
5.0GHz <mode> Enables or disables access to the Brocade Mobility
7131N-FGR Access Point 5.0 GHz radio.
2.4Ghz <mode> Enables or disables access to the Brocade Mobility
7131N-FGR Access Point 2.4 GHz radio.
mesh <mode> Enables or disables the Client Bridge Mesh
Backhaul option.
hotspot <mode> Enables or disables the Hotspot mode.
max-mu <number> Defines the maximum number of MU able to
operate within the WLAN (default = 127 MUs).
idle- timeout <minutes> Sets the interval the access point uses to timeout
idle MUs from WLAN inclusion. Set between 1
-65532 minutes. Default is 30 minutes.
security <name> Sets the security policy to the WLAN (1-32).
acl <name> Sets the MU ACL policy to the WLAN (1-32).
passwd <ascii
string> Defines a password used if the WLAN’s security
policy uses a server-based authentication scheme.
no-mu-mu <mode> Enables or disables MUs associated to the same
WLAN to not communicate with each other.
sbeacon <mode> Enables or disables the AP from transmitting the
ESSID in the beacon.
bcast <mode> Enables or disables the Brocade Mobility
7131N-FGR Access Point from accepting broadcast
IDs from MUs. Broadcast IDs are transmitted
without security.
qos <name> The index name representing the QoS policy used
with this WLAN.
add-wlan Apply the changes to the modified WLAN and exit.
rate-limiting <mode> Enables or disables MU Rate Limiting
limit w2wl <rate limit> Sets the per-mu rate limit in kb (in the
wired-to-wireless direction)
limit wl2w <rate limit> Sets the per-mu rate limit in kb (in the
wireless-to-wired direction)