Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 297)

Brocade Mobility 7131N-FGR Product Reference Guide 285
53-1001947-01
Network commands
8
BR7131N>admin(network.wan)> set
Defines the configuration of the Brocade Mobility 7131N-FGR Access Point WAN port.
Syntax
Example
admin(network.wan)>
admin(network.wan)>set dhcp disable
admin(network.wan)>set ipadr 157.169.22.5
admin(network.wan)>set dgw 157.169.22.1
admin(network.wan)>set dns 1 157.169.22.2
admin(network.wan)>set auto-negotiation disable
admin(network.wan)>set speed 10M
admin(network.wan)>set duplex half
admin(network.wan)>set mask 255.255.255.000
admin(network.wan)>set pppoe mode enable
admin(network.wan)>set pppoe type chap
admin(network.wan)>set pppoe user jk
admin(network.wan)>set pppoe passwd @#$goodpassword%$#
admin(network.wan)>set pppoe ka enable
admin(network.wan)>set pppoe idle 600
se
t wan enable/disable Enables or disables the Brocade Mobility 7131N-FGR
Access Point WAN port.
dhcp enable/disable Enables or disables WAN DHCP Client mode.
ipadr <idx> <a.b.c.d> Sets up to 8 (using <indx> from 1 to 8) IP addresses
<a.b.c.d> for the
Brocade Mobility 7131N-FGR Access Point WAN interface.
mask <a.b.c.d> Sets the subnet mask for the Brocade Mobility
7131N-FGR Access Point WAN interface.
dgw <a.b.c.d> Sets the default gateway IP address to <a.b.c.d>.
dns <idx> <a.b.c.d> Sets the IP address of one or two DNS servers, where
<indx> indicates either the primary (1) or secondary (2)
server, and <a.b.c.d> is the IP address of the server.
auto-negotia
tion enable/disable Enables or disables auto-negotiation for the access point
WAN port.
speed <mbps> Defines the access point WAN port speed as either 10
Mbps or 100 Mbps.
duplex <mode> Defines the access port WAN port duplex as either half or
full.
pppoe mode enable/disable Enables or disables PPPoE.
user <name> Sets PPPoE user name.
passwd <password> Defines the PPPoE password.
ka enable/disable Enables or disables PPPoE keepalive.
idle <time> Sets PPPoE idle time.
type <auth-type> Sets PPPoE authentication type.