Brocade Mobility 7131N-FGR Access Point Product Reference Guide (Supporting software release 4.0.0.0-35GRN and later) - Manual (Page 53)

Brocade Mobility 7131N-FGR Product Reference Guide 41
53-1001947-01
Basic configuration
3
• Stop Bits - 1
• No Parity
• No Flow Control
4. Press <ESC> or <Enter> to access the access point CLI.
5. Enter the default username of “admin” and the default password of “admin123.”
As this is the first time you are logging into the access point, you are prompted to enter a new
password and set the county code. Refer to
“Country codes” on page 564 for a list of each
available countries two digit country code.
6. At the CLI prompt (admin>), type “summary.”
The access point’s LAN IP address will display.
7. Using a Web browser, use the access point’s IP address to access the access point.
8. Refer to “Basic configuration” on page 41 for instructions on the initial (basic) configuration of
the access point.
Basic configuration
Configuring your browser for Brocade Mobility 7131N-FGR Access Point
support
A Brocade Mobility 7131N-FGR Access Point is compliant with the FIPS140-2 standard. The
Brocade Mobility 7131N-FGR Access Point is only accessible using browsers that support the TLS
1.0 protocol. The Brocade Mobility 7131N-FGR Access Point is not accessible by browsers
supporting the SSL 2.0 or SSL 3.0 protocols. Additionally, ensure JRE (version 1.6 or above) is
installed on the computer accessing the Brocade Mobility 7131N-FGR Access Point GUI applet. The
following sections describe how to change your browser settings using either Internet Explorer or
Mozilla Firefox in order to correctly launch and display the Brocade Mobility 7131N-FGR Access
Point GUI applet. Without these browser modifications, you will not be able to access the Brocade
Mobility 7131N-FGR Access Point GUI applet.
CAUTION
With both the Internet Explorer and Mozilla Firefox browser configurations, screens may display
stating Website certificates cannot be validated or have been certified by an unknown authority.
Do not exit the browser configuration, as these messages will occur with only the initial Brocade
Mobility 7131N-FGR Access Point browser configuration.
Accessing the Brocade Mobility 7131N-FGR Access Point using Internet Explorer
To define the browser settings needed to access the Brocade Mobility 7131N-FGR Access Point
using Windows Internet Explorer:
1. Open the Internet Explorer browser and open the Tools > Internet Options menu.
2. Select the Advanced tab.