Triton MAKO 2000 Operation Manual - Manual (Page 116)

5-76
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
T RITON S YSTEMS , I NC .
M AKO C ASH D ISPENSER O PERATION M ANUAL
F
UNCTION
: ENTER PIN MASTER KEY
F
ACTORY
D
EFAULT
: PROCESSOR-SPECIFIC
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select KEY MANAGEMENT.
4.) Choose the ENTER PIN MASTER KEY option.
D
ESCRIPTION
:
IMPORTANT: The PIN MASTER KEY must be entered before the PIN Working key.
NOTE: The PIN MASTER KEY was referred to as the MASTER KEY in previous versions
of ATM software.
The PIN MASTER KEY is used to protect the PIN WORKING KEY during manual entry or
downloading of the working key. This key is a 16-character string, consisting of the digits 0-9 and
the letters A-F. Your processor must provide you with the PIN MASTER KEY.
For security reasons, when entering this key, a ‘*’ is displayed in place of the actual character.
Since it is not possible to view the key while it is entered, the key must entered in twice to make
sure it was entered properly.
To enter a digit 0-9, simply press the key that has that digit, and a ‘*’ will appear. To enter the
letters A-F, first press the <BLUE> key, then press the key that has the letter you want on it. The
first press of the key will display the first character above the number. Subsequent presses will
display the characters in sequence. When the character you want is displayed, press the <RIGHT
ARROW> key to ‘lock in’ the letter. If your next character is a letter, you must press the <BLUE>
key again. Press the <CHANGE> key to clear the entry and start over. Press the <LEFT ARROW>
key to back up and erase a character.
Normally, the PIN MASTER KEY contains only one part. However, some keys may contain
multiple parts. If this is the case, separate individuals will hold the parts. If your key has multiple
parts you must answer the question “ANOTHER KEY PART?”, with a YES until all parts are
entered.