Triton MAKO 2000 Operation Manual - Manual (Page 28)

3-6
T RITON S YSTEMS , I NC .
S
ECTION
3 - O
PERATION AND
S
ETUP
M AKO C ASH D ISPENSER O PERATION M ANUAL
**NOTE**
The operator of the Mako Dispenser must change the MASTER PASS-
WORD to a new number when the installation is complete.
The Top Menu serves an alternative purpose in the event of a machine malfunction or other error
condition. Such conditions are normally reported by an “OUT OF SERVICE” message screen.
The typical response to this message is to reset the Cash Dispenser. After resetting the Cash Dis-
penser the Top Menu screen will display any applicable status messages and error code num-
bers.
The two options presented in such instances will be RESET ERROR and MANAGEMENT
FUNCTIONS. Press RESET ERROR to attempt to clear the error, or enter the MANAGEMENT
FUNCTIONS area, as desired. See Section 8, Error Recovery, for more information.
I
NITIAL
M
AKO
D
ISPENSER
C
ONFIGURATION
There are seven configuration parameters that must be set when a Mako Dispenser is installed.
These parameters do not need to be set in any particular order, but they MUST be entered into the
Mako Dispenser to enable customer transactions to take place. Once they are set, they are retained
internally, even when the Mako Dispenser is turned off.
Detailed procedures describing the step-by-step setup of each terminal parameter are located in
Section 5 of this manual.
•
Terminal Number
The TERMINAL NUMBER is a unique string of alphanumeric characters (numbers and/or
letters) that identifies your Mako Dispenser to the processor. The TERMINAL NUMBER is
assigned to your Mako Dispenser by your processor
The TERMINAL NUMBER and TELEPHONE NUMBER MUST be set before the Mako
Dispenser can go on-line and before the communications key can be downloaded.
•
Telephone Number
The Mako Dispenser communicates to your host processor over a dial up phone line. The
phone number of the processor must be entered before live transactions can be performed.