Triton MAKO 2000 Operation Manual User Manual
Page 203
A-3
T
RITON
S
YSTEMS
, I
NC
.
APPENDIX A - MECHANICAL COMBINATION LOCK INSTRUCTIONS
M
AKO
C
ASH
D
ISPENSER
O
PERATION
M
ANUAL
C
HANGING
THE
C
OMBINATION
Select three new numbers. DO NOT use any number between 1 and 20 for the last number.
For maximum security, do not use numbers that end in 0 or 5, and do not use numbers in sequence: e.g., ’27-48-86'
is not as good as ’27-86-48". Perform the following steps:
1.
Dial the existing combination on the opening index (see steps 1-2-3 above, or the directions for opening when
on the factory setting). Open door of container.
2.
Dial the existing combination again, using the changing index.
3.
With the last number set at the changing index, hold the dial securely and insert the change key in the keyhole
in the back of the lock. Make sure the wing is entirely inside the lock and comes to a positive stop (see Figure
1) before turning the key.
***WARNING***
NEVER INSERT THE CHANGE KEY IN THE LOCK WHEN THE COVER IS
REMOVED. BEFORE TURNING THE CHANGE KEY, MAKE SURE THE WING
OF THE KEY IS FULLY INSERTED INTO THE LOCK.
4.
Turn key one-quarter turn to the LEFT (see Figure 1). With the change key in this position, set the new com-
bination as follows: turn the dial to the LEFT, stopping when the first number of the new combination aligns
with the changing index the FOURTH time.
5.
Turn dial to the RIGHT, stopping when the second number is aligned with the changing index, the THIRD
time.
6.
Turn the dial to the LEFT, stopping when the third number is aligned with the changing index, the SECOND
time. Holding the dial in this position, turn the change key back to the RIGHT and remove it. (See Figure 2.)
The new combination you have chosen is now set in the lock,
***CAUTION***
BEFORE CLOSING THE UNIT
TRY THE NEW COMBINATION SEVERAL TIMES
USING THE OPENING INDEX.
FIGURE 1
FIGURE 2