Triton MAKO 2000 Operation Manual - Manual (Page 121)

5-81
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
T RITON S YSTEMS , I NC .
M AKO C ASH D ISPENSER O PERATION M ANUAL
F
UNCTION
: ENTER PIN WORKING KEY
F
ACTORY
D
EFAULT
: PROCESSOR-SPECIFIC
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select KEY MANAGEMENT.
4.) Choose the ENTER PIN WORKING KEY option.
D
ESCRIPTION
:
NOTE: The PIN WORKING KEY was referred to as the COMMS KEY in previous versions
of ATM software.
The PIN WORKING KEY is used to verify the customer Personal Identification Number during
live transactions. This key is a 16-character string, consisting of the digits 0-9 and the letters A-F.
Your processor must provide you with the PIN WORKING KEY.
For security reasons, when entering this key, a ‘*’ is displayed in place of the actual character.
Since it is not possible to view the key while it is entered, the key must entered in twice to make
sure it was entered properly.
To enter a digit 0-9, simply press the key that has that digit, and a ‘*’ will appear. To enter the
letters A-F, first press the <BLUE> key, then press the key that has the letter you want on it. The
first press of the key will display the first character above the number. Subsequent presses will
display the characters in sequence. When the character you want is displayed, press the <RIGHT
ARROW> key to ‘lock in’ the letter. If your next character is a letter, you must press the <BLUE>
key again. Press the <CHANGE> key to clear the entry and start over. Press the <LEFT ARROW>
key to back up and erase a character.
Normally, the PIN WORKING KEY contains only one part. However, some keys may contain
multiple parts. If this is the case, separate individuals will hold the parts. If your key has multiple
parts you must answer the question “ANOTHER KEY PART?”, with a YES until all parts are
entered.