Triton MAKO 2000 Operation Manual - Manual (Page 127)

5-87
S
ECTION
5 - M
ANAGEMENT
F
UNCTIONS
T RITON S YSTEMS , I NC .
M AKO C ASH D ISPENSER O PERATION M ANUAL
F
UNCTION
: DATAPAK ACCESS CODE
F
ACTORY
D
EFAULT
: OFF
A
CCESS
I
NSTRUCTIONS
:
1.) Select TERMINAL CONFIGURATION from the
MANAGEMENT FUNCTIONS menu.
2.) Select SET TERMINAL PARAMETERS.
3.) Select TELEPHONE.
4.) Select DATAPAK ACCESS CODE.
D
ESCRIPTION
:
NOTE: This feature is only available for the Triton Standard Canadian version of ATM
operating software.
This function allows you to enter the DATAPAK ACCESS CODE, and to turn the DataPak feature
On or OFF. The DATAPAK ACCESS CODE is provided by the DataPak processing organization,
and is an identification number which enables the DataPak processing organization to correctly
identify and route data traffic between the terminal and the transaction processor.
The current state of the DATAPAK ACCESS CODE feature is shown as either ON or OFF in the
label on the left-hand side of the display. Press the button next to this label to toggle the state of the
feature between ON and OFF.
IMPORTANT: When using the DATAPAK communications protocol, ensure the terminal’s
Primary and Backup Telephone Numbers are configured to dial the DataPak processing
organization (NOT the transaction processor!).
E
RROR
C
ONDITIONS
:
If a DATAPAK-based communications network is being used, the DATAPAK ACCESS CODE
feature must turned ON and the code must be entered correctly to enable message traffic between
the ATM and the processor to take place.