Work Sharp WS2000 Tool Sharpener & Grinder Step By Step Guide - Manual (Page 11)

Method:
• Place the coarse grit slotted Edge-
Vision™ abrasive face down and
remove the Top Tool Rest for
increased visibility.
• Look down through the spinning
wheel into the Edge-Vision™ Port.
• Slowly bring tool to be sharpened
into the Edge-Vision™ port at the
2:00 position and contact the heel
of the cutting edge to the abrasive
surface.
• Determine location of area being
sharpened by watching where the
black marker is being removed from
the tool.
• Slowly move the tool to remove all
the black marker.
• Edge should now be sharp and have
an even surface finish.
1
2
3
Sharpening lathe tool in Edge-
Vision™ Port (2:00 position)
Coarse slotted abrasive (P60–P80 grit)
Using marker to darken edge
to be sharpened
4
5
6