Work Sharp WS2000 Tool Sharpener & Grinder Step By Step Guide - Manual (Page 18)

Before
WORK SHARP
After
WORK SHARP
Cold Chisels
& Masonry Chisels
Objective:
Create a new double beveled edge on a
striking chisel
Where to Sharpen:
4 Top Side Sharpening Area
Abrasive Selection:
4 Coarse solid abrasive (P60 – P80 grit)
Top Tips:
Use the Top Tool Rest to increase safety
and control.
Sharpen on the right side of the wheel so
the wheel is spinning away from you.
The Edge-Vision™ Port and coarse grit
Edge-Vision abrasives can be used for
narrow cold / masonry chisels (see Lathe
Tools).
The edge on a cold chisel should not be
sharp like a wood chisel. If it is too sharp,
the edge will be fragile and will not last.
The goal is to create a ‘like new’ edge
— sharp enough to get into tight spaces
and have a clean beveled edge.
Go from this...
...to this!