Work Sharp WS2000 Tool Sharpener & Grinder Step By Step Guide - Manual (Page 12)

Before
WORK SHARP
After
WORK SHARP
Putty Knives / Scrapers
Objectives:
4 Create a sharp and clean putty knife or
scraper.
4 Clean debris and material off blade face.
4 Sharpen the edge to appropriate
sharpness. Note: If a putty knife is too
sharp, it will cut into wallboard or soft
surfaces. Sharpen only to meet the needs
of your project.
Where to Sharpen:
4 Top Side Sharpening Area
Abrasive Selection:
4 Fine solid abrasive (P180 – P320 grit)
Top Tips:
Sharpen on the right side of the wheel so
wheel spins away from you.
The coarse solid abrasive may be needed
if blade is severely damaged or the surface
is covered in material (i.e., glue, cement,
spackle, etc.).
Go from this...
...to this!