AT&T TL86109 - Manual (Page 137)

131
Appendix
Screen messages
Intercom
The cordless handset or telephone base is on an
intercom call.
Intercom ended
The intercom call has just ended.
INTERCOM TO:
You have started the intercom process, and need to
choose a cordless handset or the telephone base you
wish to call.
Line 1 Incoming call
There is an incoming call on line 1.
Line 2 Incoming call
There is an incoming call on line 2.
Low battery
The battery needs to be charged.
Memory full
The answering system has no recording time left.
Microphone off
The cordless handset or telephone base microphone is
off. The other party cannot hear you but you can hear
the other party.
Microphone on
The cordless handset or telephone base microphone
is on.
No AC power.
System can only
access Line 1
There is no AC power. You can only use the corded
handset and dialing keys to make and answer calls. Only
line 1 is available in the event of a power failure.
No battery
The battery is not properly installed and the handset is in
the charger.
No entries
found. Try
downloading
from SIM only
There are no entries found when you download a cell
phone directory from the cell memory.
No entries
found. Try
downloading
from Phone only
There are no entries found when you download a cell
phone directory from your SIM card.
There are no entries found in either the cell or SIM card
when you download a cell phone directory from both
memories.
No connected cellular
phones
There is no cellular phone connected to the base.
No line
There is no telephone line connected.
No message
There is no message recorded on the answering system.
No signal.
Call ended
The phone lost the connection with the telephone base
or did not have a strong enough signal and the phone
call ended.
Not available
at this time
Someone else is already using the directory or caller ID
history.
ON HOLD
A call has been put on hold.