AT&T TL86109 - Manual (Page 14)

8
Getting started
Telephone base installation
If you subscribe to high-speed Internet service (DSL - digital subscriber line)
through your telephone line(s), you must install a DSL filter between each
telephone line cord and telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Please contact your DSL service
provider for more information about DSL filters.
Option 1: If you have a 2-line wall jack, install the telephone base as
shown below.
DSL filter (not included)
is required if you have
DSL high-speed Internet
service.
Black telephone line cord
Route the cords
into the slots.
Plug the small end of
the AC power adapter
into the power jack
at the bottom of the
telephone base.
Plug the large end
of the AC power
adapter into a power
outlet not controlled
by a wall switch.
Plug one end of the
black telephone line
cord into the
LINE 1/L1+L2
telephone jack at
the bottom of the
telephone base.
Raise the antenna.
Plug the other end of the
black telephone line cord
into the DSL filter
(if required).
Plug the other end
of the coiled handset
cord into the jack at
the bottom of the
telephone base.
Line 1 + line 2
telephone wall jack
Use a telephone line cord
with 4-conductor (not
included) to connect the
DSL filter and the 2-line
telephone wall jack.