AT&T Partner II - Manual (Page 36)

Assembling MLS-Model Telephones
Desk Mounting (Stand Required for MLS-34D)
A) Plug one end of the handset
1
cord into the jack on the handset and
the other end into the small jack on the
left side of the base. B) For all but
MLS-34D phones, plug one end of the
phone cord into the big jack on the
bottom of the phone; push the cord into
place along the channel on the bottom
of the phone. C) To raise the phone’s
angle, go to Step 2. Otherwise, go to
Step 3.
Wall Mounting (Stand Required)
2
To install the phone stand, gently
place the phone upside down with the
low end of the phone to your right.
Insert the tab on the narrow end of the
stand into the right slot on the bottom of
the phone. (For an MLS-34D phone,
feed the cord through the stand and
plug it in.) Then insert the other tab into
the left slot, pushing the stand down
and slightly inward until the tab locks
into place.
1
Reverse the plastic hook that is
located in the earpiece part of the
handset cradle.
NOTE: These wall mounting
instructions apply to corded MLS-
model phones only. To wall mount an
MLC-6 cordless phone, follow the
instructions in the booklet provided with
the phone.
2
To install the telephone stand,
gently place the phone upside down
with the low end of the phone to your
right. Insert the tab on the narrow end
of the stand into the left slot on the
bottom of the phone. Then insert the
other tab into the right slot, pushing the
stand down and slightly inward until
the tab locks into place.
CAUTION:
Do not unscrew the bottom of the
phone. To do so will expose you
to a risk of electrical shock.
3
A) Remove the plastic cover from
the phone and place a labeled button
sheet on the phone so the holes on the
sheet fit over the buttons. Carefully
replace the plastic cover. B) Slide the
Quick Reference card under the
telephone.
3
A) Insert the short phone cord
through the center of the stand and plug
it into the jack on the bottom of the
phone, then plug the other end into the
modular wall jack. Mount the phone on
the wall jack using the screw keyholes
on the base of the stand. For proper
mounting, the wall jack must be an
AT&T 630B connecting block. Finally,
connect the handset cord as described
in “Desk Mounting,” Step 1A above. B)
Remove the plastic cover from the
phone and place a labelled button
sheet on the phone as in Step 3A above.
Installing the Hardware 2-11