Crystal nVision Lab Reference - Manual (Page 15)

Chassis  13
nVision Operation Manual
Recording
 Start a Recording
Press the
(
record
)
button until the red LED indicator flashes.
 View the current Run Tag during a recording
 Erase All Runs
A confirmation screen will ask, Are You Sure? . Press
(
select
)
to continue and erase all the data runs on this nVision. Press the
(
back
)
button to cancel.
!
CAUTION: Never remove power (either battery or USB) during the erasing process.
—
SERIAL NUMBERS
All serial numbers can be viewed using the nVision Summary screens or in CrystalControl.
Each product has a maximum of four serial numbers, one for the chassis and one for each of the modules (upper, lower, and BARO). Chassis serial numbers
are located in the power bay or on the rear of the product in the case of the Lab Reference. Module serial numbers are located on the module and can also be
viewed in the power bay of the Reference Recorder. Serial Numbers consist of 6 numbers, with the left most digit representing the year of manufacture. For
example: 937834 was manufactured during 2009.