Dwyer TIC - Manual (Page 21)

20
Preparing the IR Camera
Setting the date and time
You need to set the Date / Time when the IR camera is turned on for the
first time.
1
Make sure that the IR camera is in null mode.(p.19)
2
Press the MENU/ENTER key then
press the UP or DOWN arrow on
the omni selector to select the
[System Setup] menu.
3
Press the UP or DOWN arrow on the
omni selector to select [Date & Time]
then press the MENU/ENTER key.
4
Setting Date and Time
•
Press the UP or DOWN arrow on
the omni selector to select an item
to change.
•
Press the LEFT or RIGHT arrow on
the omni selector to set the values.
5
After adjusting the settings, press the MENU/ ENTER key to
save changes, or press the C key to go back to upper menu
without saving.