NORD Drivesystems BU0000 - Manual (Page 39)

Control
39 BU 0000 GB
5.3.3 Management of setting values and actual values
For controlling the inverter the user can define up to 3 different setpoints and actual values (see
user manual). The setpoints and actual values are displayed according to the formatting (Button
„formatting setting value x"). The input of setpoins can be done in same way.
With the option „setting/control/ parameter set individual management" the setting values and
actual values can be managed individually. So setting values can be set for each parameter set.
With activation of a parameter set its setting values are transmitted to the frequency inverter.
This is necessary because for each parameter set the setting values and actual values can be
defined individually. The active parameter set is marked with a star.
If the option „setting/control/configuration automatically checked" was not activated, the user
can transmit the new configuration by pressing the button „update".
5.3.4 Formatting of Setpoint and/or actual value
Char Name Description
"%" 16 Bit standardised values This standardisation transforms the setpoint/actual value to a 16
Bit standardised value. Standardisation means a scaling of
value range and is between -200% and 199% of a basic value
(e.g. nominal frequency).
"16" 16 Bit not standardised By this formatting the setpoint and actual value are transformed
to 16 Bit value and transmitted to inverter and displayed without
any scaling.
"B" DigInBits By this Formatting the setpoint and actual value are transformed
to 8 Bit value. The bit status is displayed individual in check
boxes. In these check boxes each bit of setting value can be
changed.
"L" 32 Bit Low-Word By this formatting the setpoint and actual value are taken as the
low word (16 Bit) of a 32 Bit word..If there is another setpoint or
actual value parametriesed with formatting "32 Bit High-Word",
then both values are combined in the top display. The setting