NORD Drivesystems BU0000 - Manual (Page 51)

Oscilloscope
51 BU 0000 GB
trigger settings. The recording time depends on the oscilloscope memory of the device and
amounts to max. 2000s. The values are noted in the adjusted sampling rate.
The roll mode makes a recording over larger period. The noted values are transferred
immediately to the PC. Therefore the user cannot change the sampling rate. It depends on the
speed of the transmission.
4. Starting of measurement
The Start -Button activates the measurement. The event of trigger is detected. When the event
appears the record starts in the inverter. The transmission of data to NORD CON starts in the
same moment. This can be cancelled by Stop. After transferring all data a new measurement
can be started or new settings can be done by pressing the New -Button.
7.4 Measurement
After recording the measurement completely, measurements on the results can be done by
cursors.
There are two cursors available for this. The cursors can be moved by . The choice of
cursor is done by . To choose the mode `move`and `measurement`by right mouse
button the pointer has to be on display. In the measure mode the cursors can be set by left
mouse button.
The values of the measured lines 1 and 2 are displayed on cursor 1 and cursor 2. Additionally
the calculations like average values are performed. Pressing on calculation button starts the
shift of calculation.
7.5 Save and Print
The recorded series of measurement can be saved, exported or printed.
Menu item "File"