Brother NX 600 - Manual (Page 130)

UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
124
Realigning the pattern
The pattern may not be sewn correctly, depending on
the type of fabric being sewn or the sewing speed. If
this occurs, adjust the pattern while sewing on a
piece of scrap fabric that is the same as that used for
your project.
a
Attach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 37).
b
Press (Stitch selection key) in the operation
panel.
X The screen containing the various types of
stitches appears.
c
Press , , and (Arrow keys) until
is selected, and then select .
X The pattern alignment stitch is selected.
d
Start sewing.
X The pattern for making the adjustment is
sewn.
X The sewing machine stops after it has
finished sewing the pattern.
e
Check the sewn pattern.
If the part of the pattern indicated in the
illustration is sewn uniformly, the pattern is
correctly aligned.
If the pattern appears as shown below, the
stitching is misaligned in the vertical direction.
If the pattern appears as shown below, the
stitching is misaligned in the horizontal
direction.
If the pattern is not sewn correctly, follow the
steps below to adjust the sewing.
f
Press (Settings key) in the operation panel.
X The settings screen appears.
g
Press , , and (Arrow keys) until
or is selected.
To adjust the vertical position, select . To
adjust the horizontal position, select .
h
Press (OK key).
X The screen for adjusting the pattern appears.
■ Vertical pattern adjustment
■ Horizontal pattern adjustment
F3dash-BrotherE_sgml.book Page 124 Friday, September 5, 2003 5:46 PM