Brother NX 600 - Manual (Page 64)

SEWING BASICS
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
58
a Reverse/reinforcement stitch button
X After reverse/reinforcement stitches are
sewn, the sewing machine stops.
Memo
z Reverse/reinforcement stitches will not be
sewn if the start/stop button is pressed at the
end of the stitching. Be sure to press the
reverse/reinforcement stitch button at the
end of the stitching.
Automatically cutting the
thread
The sewing machine can be set to automatically cut
the threads at the end of the stitching. This is called
"programmed thread-cutting". If programmed thread-
cutting is set, automatic reverse/reinforcement
stitching is also set. This setting is convenient if a
stitch for sewing buttonholes or bar tacks is selected.
a
Turn on the sewing machine.
X The LCD comes on.
b
Select a stitch.
• For details on selecting a stitch, refer to
"Selecting stitching" (page 66).
c
Press (Settings key) in the operation panel.
X The settings screen appears.
d
Press , , and (Arrow keys) until
is selected.
e
Press (OK key).
X The screen for specifying automatic thread-
cutting appears.
1
F3dash-BrotherE_sgml.book Page 58 Friday, September 5, 2003 5:46 PM