Brother NX 600 - Manual (Page 35)

Upper Threading 29
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d
Insert the extra spool pin onto the bobbin
winder shaft.
Insert the extra spool pin so that it is
perpendicular to the bobbin winder shaft.
a Bobbin winder shaft
e
Swing down the spool pin so that it is
horizontal.
f
Place the upper thread spool for the needle on
the right side onto the extra spool pin, and
then secure it with the spool cap.
The thread should unroll from the top front of
the spool.
a Spool cap
b Spool
g
Thread the upper thread in the same way that
the upper thread for the left side was threaded.
a Thread guide cover
• For details, refer to step
h
through
j
of
"Threading the upper thread" (page 24).
h
Without passing the thread through the needle
bar thread hook, manually thread the right
needle.
Pass the thread through the eye of the needle
from the front.
• The needle threader cannot be used with the
twin needle. If the needle threader is used
with the twin needle, the sewing machine
may be damaged.
i
Attach zigzag foot "J".
• For details on changing the presser foot, refer
to "Replacing the presser foot" (page 37).
CAUTION
j
Turn on the sewing machine.
X The LCD comes on.
k
Press (Settings key) in the operation panel.
X The settings screen appears.
l
Press , , and (Arrow keys) until
is selected.
1
1 2
1
● When using the twin needle, be sure to
attach zigzag foot "J", otherwise the
needle may break or the machine may be
damaged.
F3dash-BrotherE_sgml.book Page 29 Friday, September 5, 2003 5:46 PM