Brother NX 600 - Manual (Page 146)

APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
140
Maintenance
Simple sewing machine maintenance operations are described below.
Cleaning the machine surface
If the surface of the machine is dirty, lightly soak a
cloth in neutral detergent, squeeze it out firmly, and
then wipe the surface of the machine. After cleaning
it once with a wet cloth, wipe it again with a dry
cloth.
CAUTION
Cleaning the shuttle
Sewing performance will suffer if dust collects in the
shuttle; therefore, it should be cleaned periodically.
a
Turn off the sewing machine.
CAUTION
b
Grasp both sides of the needle plate cover, and
then slide it toward you.
a Bobbin cover
X The needle plate cover is removed.
c
Turn the balance wheel toward you until the
tip of the shuttle hook aligns with the edge of
the race shelf.
a Shuttle race
b Shuttle
c Edge of the shuttle race
d Tip of the shuttle hook
● Unplug the power supply cord before
cleaning the machine, otherwise injuries
or an electric shock may occur.
● Unplug the power supply cord before
cleaning the machine, otherwise injuries
or an electric shock may occur.
1
3
1
2
4
F3dash-BrotherE_sgml.book Page 140 Friday, September 5, 2003 5:46 PM