Brother NX 600 User Manual
Page 65
Useful Functions 59
2
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
f
Press
to
select .
To return to
, press .
X
The machine is now set for programmed
thread-cutting.
g
Press
(OK key).
X
The initial stitch screen appears again, and
appears in the lower-left corner of the
screen.
• When the sewing machine is turned off, the
programmed thread-cutting setting is
cancelled.
h
Position the fabric under the presser foot, and
then press
(Start/stop button) once.
a Start/stop button
X
After reverse/reinforcement stitches are
sewn, the machine starts sewing.
i
After reaching the end of the stitching, press
(Reverse/reinforcement stitch button)
once.
This step is not necessary if a stitch such as
those for sewing buttonholes and bar tacks is
selected where reinforcement stitches are
automatically sewn.
a Reverse/reinforcement stitch button
X
After reverse/reinforcement stitches are
sewn, the sewing machine stops and cuts the
thread
Memo
z Reverse/reinforcement stitches will not be
sewn and the thread will not automatically
be cut if the start/stop button is pressed at the
end of the stitching. Be sure to press the
reverse/reinforcement stitch button at the
end of the stitching.
1
1
The thread is cut here.
F3dash-BrotherE_sgml.book Page 59 Friday, September 5, 2003 5:46 PM