Alps Electric MD-1300 - Manual (Page 109)

107
Printing on Back Print Film
Plain paper
(paper for copiers)
Curled sheet with a trans-
ferred image facing up
Plain paper
(paper for copiers)
Approximate diameter of 1 in / 25 mm
Curled sheet with a transferred
image facing up
Approximate diameter of 1 in / 25 mm
3. Lift off the finishing sheet after the paper and the film have
cooled completely.
Note
If the paper and film have not cooled completely, the film will not
come off smoothly.
4. Starting with the corners, peel off the film, making sure
that the film comes off smoothly.
Step 6
❿ ❿ ❿ ❿ ❿
Curl Correction
When you transfer an image on a thin sheet of paper, the sheet
may still be curled up after peeling off the back print film. In this
case, correct the curl with the following procedure.
1. Place a sheet of plain paper (paper for copiers) on top of
the transferred image on the curled sheet.
2. Roll up both sheets together with an approximate diam-
eter of 1 inch to resist the curl.
3. Leave them rolled up for five minutes.