Canon XEED SX6000 - Manual (Page 195)

195
Installation Manual
Maintenance
Replacing the Lamp
When the usage time of the lamp exceeds a certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.
2,700 hours to less than 3,000 hours
Prepare a new lamp when this screen is displayed.
• Only the [ ], [ ],
OK and POWER buttons are available while this screen is displayed.
• When you press the POWER button, “Push POWER button again to turn off power.”
message appears.
• After this screen has been displayed for 10 seconds and disappeared, all buttons
become operable.
• This message will not be displayed again if you select [Cancel] in response to the mes-
sage “Do you want to display this message again?”.
3,000 hours or more
If this screen is displayed, replace the lamp by referring to the procedure on page 196 .
• Only the POWER button is available while this screen is displayed.
• When you press the POWER button, the “Push POWER button again to turn off power.”
message appears.
• When this screen has disappeared after being displayed for 10 seconds, all buttons
become operable.
• You can check the usage time of the lamp in [Lamp counter] in the [System settings]
menu. ( P135 )
• This screen is not displayed when [Lamp warning display] is set to [Off]. (WX6000 /
SX6000) ( P135 )