Canon XEED SX6000 - Manual (Page 48)

Connecting the Projector
48
Connecting with VGA-DVI cable (Input signal type: [Analog PC-2] P59 )
• Use a VGA cable in which all pins are connected. If the cable is a type in which all pins
are not connected, the image may not be correctly displayed.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
will reduce the audio volume.
• The AUDIO IN terminal can be changed in the Audio in terminal select screen ( P139 ).
(WX6000 / SX6000)
Computer
Monitor output
terminal
(mini D-sub 15-pin)
AUDIO output terminal
(AUDIO OUT)
VGA cable (supplied)
When inputting corresponding audio
Audio cable (not included)
To ANALOG PC-1 /
COMPONENT IN terminal
To AUDIO IN terminal
Projector
Computer
Monitor output
terminal
(mini D-sub 15-pin)
AUDIO output terminal
(AUDIO OUT)
VGA-DVI-I cable (not included)
When inputting corresponding audio
Audio cable (not included)
To ANALOG PC-2 /
DVI-I IN terminal
To AUDIO IN terminal
Projector